Glass reactor maintenance instructions

Glass reactor maintenance instructions 1, carefully check the instrument before use, whether the glass bottle is damaged, whether the interface is consistent, pay attention to gently.

2. Wipe the connectors with a soft cloth (use a napkin instead) and apply a little vacuum grease. (The vacuum grease must be covered after use to prevent lime sand from entering.)

3. The interfaces of the glass reactor should not be tightened too tightly, and loosening and loosening should be done regularly to avoid long-term tight locking and the connector being seized.

4, first open the power switch, and then let the machine run from slow to fast, stop the machine to stop the state, and then turn off the switch.

5, everywhere PTFE switch can not be over-tightened, easy to damage the glass.

6. Each use must be done with a soft cloth to wipe all kinds of traces of oil left on the surface of the machine, stains, solvent left, keep it clean.

7. Loosen the PTFE switches after shutting down. Long-term static operation will deform the PTFE piston.

8. Regularly clean the sealing Ring by removing the sealing ring and checking if there is dirt on the shaft. Clean it with a soft cloth, then apply a little vacuum grease, and reinstall it to keep the shaft and sealing ring smooth.

9, the electric part must not enter the water, is strictly prohibited damp.

10. It is necessary to purchase genuine accessories from the factory, and casual use of Other accessories can cause fatal damage to the machine.

11. When doing any repairs or inspections of the glass reactor, it is necessary to cut off the power supply and water source first.

China Made Glass Glass Reactor Supplier: Zhengzhou Great Wall Branch Industry & Trade Co., Ltd.

Water treatment industry

Water Treatment Industry ,Water Treatment Industry Outlook,Water Treatment Industry Report,Water Treatment Industry News

Rotating Shaft Seals,Vee Packing Ring Co., Ltd. , http://www.nboilseals.com

Posted on